Jailbreak IPHONE 4and 3gs with IOS 6.0.1 using REDSNOW

1. Download RedSn0w 0.9.15b3 from here.
2. Ensure you have iOS 6.0 available for your device on your computer, if not, download the iOS 6.0 firmware file for your specific device from here.
3. Connect your iOS device to your computer, and place your iOS device into DFU mode.

4. TO enable DFU mode you will have to:

• Plug your device into your computer.
• Turn off the device.
• Hold the Power button for 3 seconds
• Hold the Home button without releasing the Power button for 10 seconds
• Release the Power Button but keep holding the Home button
• Keep holding the Home button until you are alerted by iTunes saying that it has detected a device in Recovery Mode

5. Open RedSn0w and ensure it recognizes your device at the bottom of the screen as being in DFU mode.

6. Click Extras > Select IPSW > and point to the iOS 6.0 firmware file.It should successfully identify your firmware file

7. Go back to the main page of RedSn0w, and click Jailbreak. The jailbreak will process and then it will present you with an options screen.

8. Ensure that “Install Cydia” is checked, and click Next to proceed with the jailbreak process.

9. Once the jailbreak is complete, you should be on your Lock Screen.

10. Place your iOS device back into DFU mode.

11. Go back to the Extras > Select IPSW > and reselect the iOS 6.0 firmware file again. You must select this firmware file again on beta jailbreaks, or else you will get a failure message.

12. On the Extras page click Just boot to perform a tethered boot.

13.  You should see a pineapple logo on your device’s screen after a while, as the device boots up.

14. Once the device is booted, swipe to the Home screen’s second page, and wait until the Cydia app icon appears on the page.

15. Congrats, your iOS 6.1 beta 2 device is now jailbroken using RedSn0w 0.9.15b3.